Industrial Doors


Direct Drive Roller Shutters require no drive chain; no barrel tensioning and no isolator. This means that installation is much easier. And is also extremely safe..

Design and Installation

Doors supplied upto 6500 mm W x 6500 mm H, flag guide set up as standard. No end plates. High quality pedestal bearings – the shaft does not run in direct contact with rough castings. Direct Drive Roller Shutters are pre-wired for easy installation and include a 3 phase E & N inverter plug allowing polarity to be changed easily and safely. A 16 amp socket must be provided within 1 metre of the motor drive side of the door 1500 mm from finished floor level.

Motor Details

Industrial 3 Ph 230/400v motor.
Nominal current: 5.2/3 amps.
Motor protection class: IP54.
Duty rating: 60%.
Emergency hand chain (operable from floor level).
Fully pre-wired open/stop/close push button control.
Low level 24 volt control.
Auto close function.
Photocell connections.
Impulse and deadman operation.
Safety edge connections without additional relay.
Option of radio control with timed return.